Sapphire spas and swim spas are manufactured to provide power supply access through the recess at the base of the rounded cabinet corners (see image and diagram below). There should be enough room to push the 15amp power cord through or for your electrician to use as an entry point for the conduit to supply power to your spa or swim spa.) The location 50mm in from red line, suggested below, is ideal for this method of supplying power to your new spa or swim spa.
Please confirm the best way to provide electrical access for mySpace & myGetaway with your local spa pool supplier or Sapphire Spas Head Office.
Our spa pool and swim spa models also allow for the option to install electrical conduit/flex into the concrete slab so it's concealed within the cabinet. Please use the information provided to guide your electrician on where to connect power in this way as delivery may be delayed if the power has not been positioned correctly.
IMPORTANT : the electrician should install the conduit or flex so that it rises from the concrete slab at a MAXIMUM height of 40mm above the slab surface. If the conduit is higher than 40mm, it may interfere with the equipment within your spa cabinet, which could necessitate further work by your electrician and delay Sapphire delivery date.
Download the 'tech sheet' for your particular spa or swim spa model for location of pre-power options available to you (example below of where you'll find download button once you locate your model through 'spa pools' or 'swim spas' top menu option.
Below is an example of the tech sheet for myChillout spa pool, showing measurements for pre-installing power in conduit/flex through the concrete slab so it enters under the cabinet at one of these locations shown. You must adhere to these directions to avoid interference with equipment already installed within the cabinet which may delay delivery date.
myHotTub DOES NOT have this corner recess option due to steel frame so please ensure that you've considered power access prior to installing myHotTub. Pre-installing power through your concrete slab is the best option for power supply to myHotTub. The access from rear of spa will then be run through the myHotTub cabinet by your electrician to reach the main controller box.
Technical specifications showing measurements of where to position conduit to enter spa from base
Provide this document to your electrician when they're connecting your spa to the power supply.
Spanet SV Series Control WIRING DIAGRAM (1.1 MB)
Show all
