Setting power save timers – P.SAV

17 September, 2024

Accessed via the Setup menu (see heading. below) Power Save (P.SAV) timers can be set during hours of peak power tariffs to ensure no unnecessary heating or filtration will take place during that time.

The power save setting consists of a choice of; mode, peak power period start time and peak power period end time (refer table below).

Item	Description	Notes
P.SAV	Power Save Mode -Functions disabled during peak power periods	OFF = P.SAV disabled (default) LOW = Filtration disabled, allow heating HIGH = Heating disabled, allow filtration
BGN	Begin Time - Peak power period begins	Adjustable: 00:00 - 23:59 Default = 14:00 (2PM)
END	End Time - Peak power period ends	Adjustable: 00:00 - 23:59 Default = 20:00 (8PM)

Important Notes

If P.SAV function is to be used the spa user MUST consider any sleep timers [SNZE] and adjust them accordingly. Sleep timer settings will OVERIDE any P.SAV settings
On older versions of software Power Save set to HIGH can = disable heating & filtering

Entering the Setup menu

The SV controllers feature an advanced setup menu which allows customisation of the adjustable controller settings.

Setup Menu

The SV controllers feature an advanced setup menu which allows customization of the adjustable controller settings. Menu item options are detailed in the list below.

To enter menu press and hold and buttons until [MODE]
is displayed.
Press or to navigate through menu item list
Press to enter menu item adjustment
Press or to adjust setting
Press to confirm setting and exit menu

Accessible options in the setup menu

Menu Item	Setting	Notes
MODE	Operating Mode	Normal / Away / Week Modes
FILT	Hours of filtration per day	1 to 24 hours
F.CYC	Filtration cycle blocks	Set filtration to run every 1,2,3,4,6,8,12 or 24 hrs
SNZE	Sleep time menu
1.SNZ	Sleep timer 1	[1.DAY] Days of week, [1.BGN] Begin Time, [1.END] End Time
2.SNZ	Sleep timer 2	[2.DAY] Days of week, [2.BGN] Begin Time, [2.END] End Time
R.SET	Reset sleep timers	Reset sleep timers to factory defaults
EXIT	Exit sleep time submenu
P.SAV	Power save settings	Off, Low (off-peak filtration), High (off-peak filtration & heating)
W.CLN	Automatic sanitise time	Daily run time of automatic sanitise cycle (00:00 - 23:59)
D.DIS	Default display mode	Water Temp (W.TMP), Set Temp (S.TMP) or Clock (TIME)
T.OUT	Load time out period	Pump / Blower time out period (10 to 60 minutes)
H.PMP	Heat pump operating mode	Auto (heat or cool) / Heat / Cool / Off (heat pump disabled)
H.ELE	Heat pump with SV element boost	On = Heat pump + SV element combined for heating Off = Heat pump only
EXIT	Exit setup menu

Important Notes

The setup menu item settings are stored in non-volatile memory (EEPROM) and are remembered when power is turned off. No need to reprogram settings when power is restored.

A ten (10) second idle menu time out period exists. If a button press is not detected for 10 seconds, the menu will time out and the screen will return to the default display mode.