Setting your daily Water clean Cycle – W.CLN

17 September, 2024

SV & SV Mini controllers are automatically programmed to activate a 10-minute daily sanitisation cycle at a given time, where each pump/blower is operated to purge pipe work whilst operating the filtration pump. This setting can be adjusted via the Setup Menu (see heading below) & allows the user to choose the start time of the automatic daily sanitise cycle.

Setting ranges from 00:00 to 23:59. Default = 09:00 (9AM)

Important Notes

On SV Mini controllers W.CLN cycle is fixed to run at 9:00am. Users will not be able to adjust the start time.

All SV & SV Mini controllers will skip the auto water clean cycle if the spa has been used the day before to save on electricity consumption, as the pumps have already run & purged their pipe work.

SV2, SV3, SV4 & SmartTouch touchpads have a Water clean cycle button. When pushed the spa will run a 20min purge cycle on demand.

Entering the Setup menu

The SV controllers feature an advanced setup menu which allows customisation of the adjustable controller settings.

Setup Menu

The SV controllers feature an advanced setup menu which allows customization of the adjustable controller settings. Menu item options are detailed in the list below.

To enter menu press and hold and buttons until [MODE]
is displayed.
Press or to navigate through menu item list
Press to enter menu item adjustment
Press or to adjust setting
Press to confirm setting and exit menu

Accessible options in the setup menu

Menu Item	Setting	Notes
MODE	Operating Mode	Normal / Away / Week Modes
FILT	Hours of filtration per day	1 to 24 hours
F.CYC	Filtration cycle blocks	Set filtration to run every 1,2,3,4,6,8,12 or 24 hrs
SNZE	Sleep time menu
1.SNZ	Sleep timer 1	[1.DAY] Days of week, [1.BGN] Begin Time, [1.END] End Time
2.SNZ	Sleep timer 2	[2.DAY] Days of week, [2.BGN] Begin Time, [2.END] End Time
R.SET	Reset sleep timers	Reset sleep timers to factory defaults
EXIT	Exit sleep time submenu
P.SAV	Power save settings	Off, Low (off-peak filtration), High (off-peak filtration & heating)
W.CLN	Automatic sanitise time	Daily run time of automatic sanitise cycle (00:00 - 23:59)
D.DIS	Default display mode	Water Temp (W.TMP), Set Temp (S.TMP) or Clock (TIME)
T.OUT	Load time out period	Pump / Blower time out period (10 to 60 minutes)
H.PMP	Heat pump operating mode	Auto (heat or cool) / Heat / Cool / Off (heat pump disabled)
H.ELE	Heat pump with SV element boost	On = Heat pump + SV element combined for heating Off = Heat pump only
EXIT	Exit setup menu

Important Notes

The setup menu item settings are stored in non-volatile memory (EEPROM) and are remembered when power is turned off. No need to reprogram settings when power is restored.

A ten (10) second idle menu time out period exists. If a button press is not detected for 10 seconds, the menu will time out and the screen will return to the default display mode.